BALLY/WMS REMAKE MIRROR BLADES

One pair of highly polished metal / mirror finish blades for the REMAKE and Bally/Williams games. These attach to the side of the cabinet to provide a bright and beautiful appearance. There is a hole approximately 1" in diameter for the hinge bolt so you do not have to remove it during installation.

NO INTERNATIONAL SHIPPING

MIRROR BLADE INSTALL INSTRUCTIONS

PACKAGE INCLUDES:

1 - RIGHT SIDE MIRROR

1 - LEFT SIDE MIRROR

6 – SCREWS

Installation Tips:

1. Remove protected film from mirrors prior to installation.

2. Do not pre-drill into your machine.

3. Remove all pinballs from play field. Damage could occur if you do not do this.

4. Lift playfield, fit the side mirror into cabinet, but do not force the side mirror anytime. Clamps can be used to help secure while you

putting screws in.

5. If the blades fit it, but are extremely tight, push the playfield to the

opposite side of the one you are installing the blades on.

6. Repeat the steps 1-5 on the opposite side.

7. Slowly lower your playfield making sure you do not scratch the blades. (some people use belt along the playfield sides to ensure

no scratches will occure, this can be picked up at any of your home depot or lowe’s stores).

8. Make sure your side mirrors are lined up to the sides of the

cabinet. If they are installed too high, they may block your glass channel and will not allow your glass to fit in properly.

9. If by chance you happen to scratch your mirrors, use a small

buffering wheel and buff it out.

10. If you are installing any other mods to your machine, make sure

that the mirror blades do not touch any other metal it may cause

damage to your game.

11. Double sided tape can be used as an alternative to screws if you

prefer.